Steps to Remove the Door
- Completely open each door to their respective sides.
- Push up on the top clip to reduce the pressure so that you can get the door pin out of the clip.
- Grab the each door and lift up the door until the “bottom door pin” can clear the “bottom receiving hole” located on the fireplace.
Can I remove the glass from my superior gas fireplace?
You can remove the film easily with a razorblade. Just “shave” the film off the door. When the film has been removed, you can use a window cleaner or you can buy fireplace glass cleaner which we would recommend. Again, if you need help installing your Superior Fireplace doors, see our installation guide.
How do you remove a masonry fireplace door?
This is one way. There can be masonry fireplace doors that come along with tension clips. For those doors to remove, you need to push the door upwards and remove the pin from the top and then pull the door outwards to remove the bottom pins.
How do you remove a fireplace insert surround?
To start removing one of these fireplace surrounds, you will have to chip away the plaster around the edge of the mantelpiece. This should reveal the lugs holding it to the wall. You can then go about removing the screws, which should start to release the surround from the wall.
How do I keep my fireplace glass clean?
Tips for Cleaning Fireplace Glass
- Use a wet paper towel and dip it in the cold ash found at bottom of burner.
- Clean the glass in a small circular motion, making your away across the pane of glass.
- Leave the glass to dry before wiping any excess particles down with a dry cloth or piece of newspaper.
How do you remove doors from a prefab fireplace?
How to Remove Prefab Fireplace Doors 1. Your fireplace should be turned off 2. Fully open both doors 3. Find the tension clips 4. Push on the top clip and slide the door pin out 5. Slide the bottom door pin out Doors with a frame Removing extra parts Here’s a helpful video if you are looking to replace your fireplace doors:
How do you clear a bottom receiving hole on a fireplace?
Grab the each door and lift up the door until the “bottom door pin” can clear the “bottom receiving hole” located on the fireplace. 4. Gently angle out the the bottom of the folded door towards the center of the fireplace until the top of the door can be pulled away from the “top receiving hole” on the fireplace.
Do you need to remove a frame for a fireplace?
For many prefab fireplaces the clips and tracks are missing so doors with a frame have to be installed. Below is a picture of bifold doors in a frame. If your old doors are aftermarket doors (retrofit doors), then they probably came with a surround frame (think of it as a picture frame). This frame along with the 2 doors will need to be removed.
How do you install a door in a fireplace?
The first way is with masonry screws that are screwed through brackets on the back of the frame into a hole that has been drilled into your fireplace brick. How to Remove: Simply remove the screws from the fireplace. Do this carefully so you can use the holes again when installing new doors to your fireplace.
